Current approaches to mass spectrometry (MS) require ionization of the analytes of interest. For high-mass species, the resulting charge state distribution can be complex and difficult to interpret correctly. Here, using a setup comprising both conventional time-of-flight MS (TOF-MS) and nano-electromechanical systems-based MS (NEMS-MS) in situ, we show directly that NEMS-MS analysis is insensitive to charge state: the spectrum consists of a single peak whatever the species’ charge state, making it significantly clearer than existing MS analysis. In subsequent tests, all the charged particles are electrostatically removed from the beam, and unlike TOF-MS, NEMS-MS can still measure masses. This demonstrates the possibility to measure mass spectra for neutral particles. Thus, it is possible to envisage MS-based studies of analytes that are incompatible with current ionization techniques and the way is now open for the development of cutting-edge system architectures with unique analytical capability.
Of all analytical techniques, mass spectrometry (MS) has grown fastest over the past two decades1,2; it is now recognized as an essential tool in a variety of fields of modern research ranging from environmental chemistry3 to structural biology4 or even astrophysics5. After ionization of the analytes of interest, the spectrum generated is interpreted on the mass-to-charge ratios of the different ions. Thanks to the ground-breaking development of soft ionization methods6,7, MS is no longer limited to applications involving small volatile molecules, but can be used to study massive, supramolecular assemblies8,9,10. Nevertheless, routine use of MS in the MDa to GDa range remains challenging as, in this mass range, correct analysis requires a large number of charges per particle to produce mass-to-charge ratios compatible with the detection capacities of most mass analysers11. The enormous number of charge states obtained may produce difficult to interpret spectra due to overlapping peaks9 as well as drastic changes of physical state compared with buffered solution. In some cases, the study of molecules in their ‘native’ form (due to, for example, dissociation9,12) can be made complex. Moreover, it has been estimated that only one analyte ion out of 103–105 generated at ambient pressure is generally detected13. This state of affairs has led to extensive efforts to understand and improve the efficiency of ionization and ion transmission13,14 as well as ion detection, in particular for high masses8,15.
Mass sensing has been widely performed since the mid-nineties using micro- and nanomechanical resonators, which detect changes in resonance frequency on mass accretion on their surface16,17,18. A mass resolution of a few Daltons was recently reported19. While the first nano-electromechanical systems MS (NEMS-MS) was being developed20, a procedure to simultaneously deduce both the mass and position of a single particle present on the resonator by monitoring several resonance modes was designed by the same group and later performed at the microscale21. This effort eventually culminated in real-time acquisition of NEMS-MS for single particles22. In systems equipped with standard ion sources, this experiment demonstrated that NEMS can detect and measure ionized molecules. However, NEMS-based measurements have never been benchmarked against the results obtained with a well-established MS system. This lack of comparison probably stems from the fact that NEMS operate in a mass range where there is no accepted mass standard (i.e., the atomic or molecular calibrants used in MS23,24). Furthermore, NEMS-MS has an attribute distinguishing it from all other MS systems—it can measure both neutral and ionized molecules—but this attribute has yet to be exploited.
In this article, we demonstrate the unique features of NEMS-MS using an experimental setup where both neutral and ionized metallic nanoclusters can be produced on demand. This novel hybrid setup makes it possible to acquire mass spectra for these nanoclusters by both NEMS-MS and time-of-flight MS (TOF-MS).
The setup consisted of four main vacuum chambers (see Fig. 1a): a nanocluster source, an intermediate chamber equipped with electrostatic deflection plates, a deposition chamber and an in-line TOF mass spectrometer. Metallic nanoclusters were generated using a sputtering gas aggregation technique25. Nanoclusters were then expelled into the vacuum deposition chamber (10−5 mbar) through a differential pumping stage. The metallic cluster sizes and the cluster deposition rate could be tuned by adjusting the operating parameters (see Supplementary Methods). The deposition rate was measured thanks to a quartz crystal microbalance (QCM) placed on a translational stage. Upon retraction of this stage, the nanomechanical resonator shown in Fig. 1b was exposed to the cluster flux. When both NEMS and QCM were retracted, the particle flux could enter the acceleration region of the in-line TOF mass spectrometer, where the mass-to-charge distribution of charged particles was measured. Transmission electronic microscopy (TEM) performed on nanoclusters deposited on TEM grids showed that the TOF module accurately detects the total mass distribution for the clusters26 (see Supplementary Methods). The configuration of the deposition chamber makes it possible to perform QCM, TOF-MS and NEMS-MS measurements sequentially; this setup ensures that the cluster distribution remains unchanged within the timeframe of the experiment (typically from 30 min to several hours; detailed in Supplementary Methods).
Comparison of TOF-MS and NEMS-MS
For our experiments, we chose tantalum as the analyte as it is both dense (16.6 g.cm−3) and readily condenses into large clusters. The cluster populations generated follow a log normal distribution law with mean masses of up to 4.5 MDa (diameter up to 9.5 nm). The TOF and NEMS-MS mass spectra acquired for various populations, with mean masses down to 470 kDa were compared. Excellent matching of both the central mass and the width of the main peak distribution was obtained between the two techniques, particularly for larger particles (see Supplementary Fig. 5). As the mass resolution of a nanomechanical sensor is constant over the whole mass range27, it provides lower relative uncertainty for heavier particles. This contrasts with current MS systems where the resolving power (capacity to distinguish between two peaks with similar masses) decreases as mass increases11. A comparison between NEMS-MS and TOF-MS for a cluster population centred on 2,420 kDa is presented in Fig. 2. NEMS-MS spectra displayed a single peak, but additional peaks were present on the TOF-MS spectrum. These additional peaks were visible in a wide range of operating conditions for cluster generation (clusters typically measured 4 nm or more). Regardless of the mass distribution generated, the mass ratios between these peaks remained constant and equal to 1/2 and 1/3. However, multimodal size distributions were never observed with TEM measurements26, indicating that the true particle mass distribution is represented by a single peak. The multiple peaks detected with TOF-MS can thus be attributed to the presence of multiple charge states in the compound analysed, which is a common phenomenon in current MS. Thus, different charge states lead to several peaks because ion-based MS is sensitive to the mass-over-charge ratio (m/z). This phenomenon can become problematic when a number of charge states co-exist, since it decreases the signal-to-noise ratio (because the ions of interest are spread over multiple peaks). When this occurs with mixtures to be analysed, spectral interpretation requires specific procedures to deal with overlapping multiply charged envelopes9,28,29. Moreover, the interpretation of spectra containing multiple charge states with low isotopic resolution becomes a real issue, since it can be difficult to distinguish between the presence of species at a fraction of the mass of a particular analyte of mass m and the presence of a multiply charged version of the same analyte ref. 30. To identify a species, the instrument resolution must be sufficient to resolve multiple peaks, and assign charge numbers to deduce a precise mass. NEMS-MS detection provides a clear, single peak, unlike m/z detection that displays multiple charge states. Indeed, the resolution—70 kDa as directly measured based on Allan deviation31—is amply sufficient to resolve any of the apparent peaks present on the TOF-MS spectrum, and indeed, in other acquisitions, clusters with mean masses <500 kDa were successfully measured. Figure 2 clearly shows that NEMS-MS spectra provide a clean signal, untainted by the compounding effect of multiple charge states. Consequently, this spectrum unequivocally shows that the nanoparticle population produced can be represented by a single distribution with a well-defined peak value corresponding to its mass. NEMS-MS can thus avoid possible spectrum misinterpretation or loss of information caused by peak overlap. This attribute could be of great interest when analysing mixtures, that is, for the vast majority of MS measurements.
Mass spectrum of neutral particles
The results presented here demonstrate that NEMS-MS is insensitive to charge and can be used to directly measure mass. This potentially represents a major paradigm shift in MS since ionization could be circumvented altogether. Without ionization, it will be possible to analyse compounds in their native state, regardless of their charge. To confirm that this is possible, we went on to investigate whether the NEMS device could detect neutral particles. A DC voltage of 40 V was applied to the deflection plates located in the intermediate chamber. This voltage caused charged particles (known to form in the cluster source) to deviate from the straight flow line and collide with the plate (producing a black spot on the plates, see Supplementary Fig. 2d) while neutral particles were unperturbed and continued on towards the deposition chamber. TOF and NEMS-MS spectra were acquired with and without electrostatic deflection: Figure 3 shows the first mass spectra obtained for neutral particles. While no signal was observed with the TOF module (confirming the absence of charged particles), NEMS-MS successfully measured the mass distribution for the neutral particle population. Once again, the peak mass of the undeflected, singly charged TOF spectra correlated very well with both the deflected (neutrals only) and undeflected (both ions and neutrals) NEMS-MS spectra, confirming that the mass distributions for neutral and ionized clusters were identical.
Analysis of large (supra-) molecular entities is extremely challenging using ion-based MS methods as a high number of charges is required to produce mass-to-charge ratios compatible with the detection capacity of most mass analysers11. Very few instruments are capable of resolving successive charge states in this high-mass/high-charge regime10. Moreover, not all species ionize with equal efficiency24,30. Thus, MS is inherently non-quantitative and internal standards must be used to calibrate the analytical response23. Although charge detection MS circumvents charge state assignment issues by simultaneously measuring the charge and the m/z of individual ions, it still requires highly charged particles (hundreds to thousands) when analysing massive ions8,32. In ionization-based MS in general, the extent of charging required in some cases may make it complex to study the analyte in its ‘native’ form, as it would be found in buffered solution9, and may even induce unwanted dissociation. A clear limitation of ionization-based MS is the instruments’ limit-of-detection, which is determined by the ionization source's ionization/sampling efficiency, as well as the efficiency of ion transmission and detection. For example, electrospray ionization (ESI), the preferred source for use with macroions, has a combined ionization/sampling efficiency (ratio between the ionic current after the inlet capillary and the total spray current) well <1% (ref. 14). This is due in part to a rapidly expanding charged droplet/ion plume caused by Coulomb repulsion and to the shape of the electric field, which disperses the sample across a much larger area than that of the inlet to the mass spectrometer. Standard ion detectors also have a diminished efficiency at high masses due to their exponentially decreasing quantum efficiency15. During our experiments, only one particle out of a few million entering the TOF spectrometer was generally detected by the micro channel plate detector (MCP). This is mainly due to the proportion of charged particles (25%) and to the secondary electron yield of the MCP (measured in the 10−6 range, as expected with this high-mass range). The yield of the TOF-MCP pair can be improved by increasing the voltage, but not by much more than a factor of 50. On the other hand, one particle out of a hundred million particles was detected by our single NEMS detector despite its small cross-section (around 2 μm2). We believe it is feasible to achieve ∼10% detection efficiency through use of ultradense arrays of nanoscale resonators placed in a configuration covering the entire particle beam. Elsewhere we have demonstrated the requisite CMOS-compatible techniques for very large scale integration of NEMS33.
The suitability of NEMS-MS for analysis of both biological and metallic particles in the MDa to the GDa range has already been shown22. In this study, we demonstrate that NEMS-MS directly measures mass independently of charge. This clarifies the spectrum obtained, simplifying analysis and facilitating the identification of the sample. We demonstrate directly, for the first time, that NEMS-MS is compatible with analysis of neutral particles. This result makes the development of weakly ionizing or non-ionizing methods for the transfer of particles into the gas phase highly relevant. Microdispensing could be particularly suitable for high-mass entities. For example, surface acoustic wave nebulization is an ionization technique that has been shown to be even softer than electrospray ionization34. In addition, particles have almost no velocity as they reach the mass spectrometer inlet, and can thus be sampled with optimal efficiency. Combining nebulizers and ultradense arrays of NEMS offers the potential of new analytical capabilities and limits-of-detection several orders of magnitude lower than today’s technology. These features could help elucidate unsolved questions in various fields, such as the study of new materials8, large dendrimers in analytical chemistry35,36 or easily dissociated, poorly soluble membrane proteins37 in structural biology. A similar combination could also be used to monitor nanoparticle levels in the environment and residual diseases in real time.
How to cite this article: Sage, E. et al. Neutral particle mass spectrometry with nanomechanical systems. Nat. Commun. 6:6482 doi: 10.1038/ncomms7482 (2015).
We acknowledge partial support from the LETI Carnot Institute NEMS-MS project. We also thank Carine Marcoux for her support with the device fabrication, A.-K. Stark for technical discussions as well as Professor Jean-Claude Tabet for his advice on the writing of the manuscript. S.H. would like to thank Professor Dan Frost for carefully proofreading the text.
Supplementary Figures 1-7, Supplementary Methods and Supplementary References
This work is licensed under a Creative Commons Attribution 4.0 International License. The images or other third party material in this article are included in the article’s Creative Commons license, unless indicated otherwise in the credit line; if the material is not included under the Creative Commons license, users will need to obtain permission from the license holder to reproduce the material. To view a copy of this license, visit http://creativecommons.org/licenses/by/4.0/