Abstract
Wear of sliding contacts leads to energy dissipation and device failure, resulting in massive economic and environmental costs1. Typically, wear phenomena are described empirically2, because physical and chemical interactions at sliding interfaces are not fully understood at any length scale. Fundamental insights from individual nanoscale contacts are crucial for understanding wear at larger length scales3, and to enable reliable nanoscale devices, manufacturing and microscopy4,5,6. Observable nanoscale wear mechanisms include fracture7 and plastic deformation8, but recent experiments9,10,11 and models12 propose another mechanism: wear via atom-by-atom removal (‘atomic attrition’), which can be modelled using stress-assisted chemical reaction kinetics13. Experimental evidence for this has so far been inferential. Here, we quantitatively measure the wear of silicon—a material relevant to small-scale devices14—using in situ transmission electron microscopy. We resolve worn volumes as small as 25 ± 5 nm3, a factor of 103 lower than is achievable using alternative techniques15,16. Wear of silicon against diamond is consistent with atomic attrition, and inconsistent with fracture or plastic deformation, as shown using direct imaging. The rate of atom removal depends exponentially on stress in the contact, as predicted by chemical rate kinetics13. Measured activation parameters are consistent with an atom-by-atom process17. These results, by direct observation, establish atomic attrition as the primary wear mechanism of silicon in vacuum at low loads.
This is a preview of subscription content, access via your institution
Access options
Subscribe to this journal
Receive 12 print issues and online access
$259.00 per year
only $21.58 per issue
Buy this article
- Purchase on Springer Link
- Instant access to full article PDF
Prices may be subject to local taxes which are calculated during checkout
Similar content being viewed by others
References
Jost, H. Tribology—origin and future. Wear 136, 1–17 (1990).
Lim, S. & Ashby, M. Overview no. 55 wear-mechanism maps. Acta Metall. 35, 1–24 (1987).
Mate, C. M. Tribology on the Small Scale: A Bottom Up Approach to Friction, Lubrication, and Wear Ch. 1 (Oxford Univ. Press, 2008).
Maboudian, R. & Carraro, C. Surface chemistry and tribology of MEMS. Annu. Rev. Phys. Chem. 55, 35–54 (2004).
Piner, R. D., Zhu, J., Xu, F., Hong, S. & Mirkin, C. A. ‘Dip-pen’ nanolithography. Science 283, 661–663 (1999).
Giessibl, F. Advances in atomic force microscopy. Rev. Mod. Phys. 75, 949–983 (2003).
Liu, J. et al. Preventing nanoscale wear of atomic force microscopy tips through the use of monolithic ultrananocrystalline diamond probes. Small 6, 1140–1149 (2010).
Merkle, A. P. & Marks, L. D. Liquid-like tribology of gold studied by in situ TEM. Wear 265, 1864–1869 (2008).
Gnecco, E., Bennewitz, R. & Meyer, E. Abrasive wear on the atomic scale. Phys. Rev. Lett. 88, 215501 (2002).
Gotsmann, B. & Lantz, M. Atomistic wear in a single asperity sliding contact. Phys. Rev. Lett. 101, 125501 (2008).
Bhaskaran, H. et al. Ultralow nanoscale wear through atom-by-atom attrition in silicon-containing diamond-like carbon. Nature Nanotech. 5, 181–185 (2010).
Gao, G., Mikulski, P. & Harrison, J. Molecular-scale tribology of amorphous carbon coatings: effects of film thickness, adhesion, and long-range interactions. J. Am. Chem. Soc. 124, 7202–7209 (2002).
Hanggi, P., Talkner, P. & Borkovec, M. Reaction-rate theory: fifty years after Kramers. Rev. Mod. Phys. 62, 251–341 (1990).
Kim, S. H., Asay, D. B. & Dugger, M. T. Nanotribology and MEMS. Nano Today 2, 22–29 (2007).
Liu, J., Notbohm, J. K., Carpick, R. W. & Turner, K. T. Method for characterizing nanoscale wear of atomic force microscope tips. ACS Nano 4, 3763–3772 (2010).
Chung, K. & Kim, D. Fundamental investigation of micro wear rate using an atomic force microscope. Tribol. Lett. 15, 135–144 (2003).
Zhu, T., Li, J., Lin, X. & Yip, S. Stress-dependent molecular pathways of silica–water reaction. J. Mech. Phys. Solids 53, 1597–1623 (2005).
Archard, J. F. Contact and rubbing of flat surfaces. J. Appl. Phys. 24, 981–988 (1953).
Jia, K. & Fischer, T. Sliding wear of conventional and nanostructured cemented carbides. Wear 203, 310–318 (1997).
D'Acunto, M. Theoretical approach for the quantification of wear mechanisms on the nanoscale. Nanotechnology 15, 795–801 (2004).
Jacobs, T. D. B., Gotsmann, B., Lantz, M. A. & Carpick, R. W. On the application of transition state theory to atomic-scale wear. Tribol. Lett. 39, 257–271 (2010).
Bennewitz, R. & Dickinson, J. T. Fundamental studies of nanometer-scale wear mechanisms. Mater. Res. Soc. Bull. 33, 1174–1180 (2008).
Sader, J., Chon, J. & Mulvaney, P. Calibration of rectangular atomic force microscope cantilevers. Rev. Sci. Instrum. 70, 3967–3969 (1999).
Marks, L. D., Warren, O. L., Minor, A. M. & Merkle, A. P. Tribology in full view. Mater. Res. Soc. Bull. 33, 1168–1173 (2008).
Mo, Y., Turner, K. T. & Szlufarska, I. Friction laws at the nanoscale. Nature 457, 1116–1119 (2009).
Briscoe, B. J. & Evans, D. C. B. The shear properties of Langmuir–Blodgett layers. Proc. R. Soc. A 380, 389–407 (1982).
Maugis, D. Adhesion of spheres: the JKR–DMT transition using a Dugdale model. J. Colloid Interface Sci. 150, 243–269 (1992).
Derjaguin, B. V., Muller, V. & Toporov, Y. P. Effect of contact deformations on the adhesion of particles. J. Colloid Interface Sci. 53, 314–326 (1975).
Chung, K., Lee, Y. & Kim, D. Characteristics of fracture during the approach process and wear mechanism of a silicon AFM tip. Ultramicroscopy 102, 161–171 (2005).
Stuart, S., Tutein, A. & Harrison, J. A reactive potential for hydrocarbons with intermolecular interactions. J. Chem. Phys. 112, 6472–6486 (2000).
Acknowledgements
The authors thank K.T. Turner and J. Li for helpful discussions, D. Yates and R. Major for microscopy and equipment assistance, and D.S. Grierson for programming assistance. Use of the facilities of the Pennsylvania Regional Nanotechnology Facility is acknowledged. Funding from the National Science Foundation (grants CMMI 1200019, CMMI-0826076, IIP-0823002 and DGE-0221664) is acknowledged.
Author information
Authors and Affiliations
Contributions
T.D.B.J. designed the test set-up, performed all testing and developed analysis routines. R.W.C. supervised the research and oversaw the analysis. Both authors prepared the manuscript.
Corresponding author
Supplementary information
Supplementary information
Supplementary information (PDF 932 kb)
Supplementary movie S1
Supplementary movie S1 (MP4 6925 kb)
Rights and permissions
About this article
Cite this article
Jacobs, T., Carpick, R. Nanoscale wear as a stress-assisted chemical reaction. Nature Nanotech 8, 108–112 (2013). https://doi.org/10.1038/nnano.2012.255
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1038/nnano.2012.255
This article is cited by
-
Switchable tribology of ferroelectrics
Nature Communications (2024)
-
Shear-activation of mechanochemical reactions through molecular deformation
Scientific Reports (2024)
-
Comparing the Tribological Performance of Water-Based and Oil-Based Drilling Fluids in Diamond–Rock Contacts
Tribology Letters (2024)
-
Erosion-inhibiting potential of the stannous fluoride-enriched CPP-ACP complex in vitro
Scientific Reports (2023)
-
Tribocatalytically-active nickel/cobalt phosphorous films for universal protection in a hydrocarbon-rich environment
Scientific Reports (2023)