Skip to main content

Thank you for visiting nature.com. You are using a browser version with limited support for CSS. To obtain the best experience, we recommend you use a more up to date browser (or turn off compatibility mode in Internet Explorer). In the meantime, to ensure continued support, we are displaying the site without styles and JavaScript.

Tailoring high-temperature radiation and the resurrection of the incandescent source

Nature Nanotechnology volume 11, pages 320–324 (2016)Cite this article

Subjects

Abstract

In solar cells, the mismatch between the Sun's emission spectrum and the cells’ absorption profile limits the efficiency of such devices1, while in incandescent light bulbs, most of the energy is lost as heat2. One way to avoid the waste of a large fraction of the radiation emitted from hot objects is to tailor the thermal emission spectrum according to the desired application. This strategy has been successfully applied to photonic-crystal emitters at moderate temperatures3,4,5,6,7,8, but is exceedingly difficult for hot emitters (>1,000 K)9,10,11,12,13,14. Here, we show that a plain incandescent tungsten filament (3,000 K) surrounded by a cold-side nanophotonic interference system optimized to reflect infrared light and transmit visible light for a wide range of angles could become a light source that reaches luminous efficiencies (∼40%) surpassing existing lighting technologies, and nearing a limit for lighting applications. We experimentally demonstrate a proof-of-principle incandescent emitter with efficiency approaching that of commercial fluorescent or light-emitting diode bulbs, but with exceptional reproduction of colours and scalable power. The ability to tailor the emission spectrum of high-temperature sources may find applications in thermophotovoltaic energy conversion15,16,17,18 and lighting.

Your institute does not have access to this article

Relevant articles

Open Access articles citing this article.

Access options

Buy article

Get time limited or full article access on ReadCube.

$32.00

Buy

All prices are NET prices.

Figure 1: Potential of cold-side thermal emission tailoring.
Figure 2: Effective emissivity of an optimally enclosed structure.
Figure 3: Simulation and experimental measurements over a wide range of wavelengths and angles.
Figure 4: Experimental demonstration of thermal emission tailoring.

References

  1. Shockley, W. & Queisser, H. J. Detailed balance limit of efficiency of p–n junction solar cells. J. Appl. Phys. 32, 510–519 (1961).

    CAS  Article  Google Scholar 

  2. US Department of Energy. Lighting Basics (accessed May 2015); http://energy.gov/eere/energybasics/articles/lighting-basics

  3. Greffet, J.-J. et al. Coherent emission of light by thermal sources. Nature 416, 61–64 (2002).

    Article  Google Scholar 

  4. De Zoysa, M. et al. Conversion of broadband to narrowband thermal emission through energy recycling. Nature Photon. 6, 535–539 (2012).

    CAS  Article  Google Scholar 

  5. Inoue, T., De Zoysa, M., Asano, T. & Noda, S. Realization of dynamic thermal emission control. Nature Mater. 13, 928–931 (2014).

    CAS  Article  Google Scholar 

  6. Raman, A. P., Anoma, M. A., Zhu, L., Rephaeli, E. & Fan, S. Passive radiative cooling below ambient air temperature under direct sunlight. Nature 515, 540–544 (2014).

    CAS  Article  Google Scholar 

  7. Liu, X. et al. Taming the blackbody with infrared metamaterials as selective thermal emitters. Phys. Rev. Lett. 107, 045901 (2011).

    Article  Google Scholar 

  8. Han, S. E., Stein, A. & Norris, D. J. Tailoring self-assembled metallic photonic crystals for modified thermal emission. Phys. Rev. Lett. 99, 053906 (2007).

    CAS  Article  Google Scholar 

  9. Schlemmer, C., Aschaber, J., Boerner, V. & Luther, J. Thermal stability of micro-structured selective tungsten emitters. AIP Conf. Proc. 653, 164–173 (2003).

    CAS  Article  Google Scholar 

  10. Sai, H., Kanamori, Y. & Yugami, H. High-temperature resistive surface grating for spectral control of thermal radiation. Appl. Phys. Lett. 82, 1685–1687 (2003).

    CAS  Article  Google Scholar 

  11. Nagpal, P. et al. Fabrication of carbon/refractory metal nanocomposites as thermally stable metallic photonic crystals. J. Mater. Chem. 21, 10836–10843 (2011).

    CAS  Article  Google Scholar 

  12. Arpin, K. A. et al. Three-dimensional self-assembled photonic crystals with high temperature stability for thermal emission modification. Nature Commun. 4, 2630 (2013).

    Article  Google Scholar 

  13. Arpin, K. A., Losego, M. D. & Braun, P. V. Electrodeposited 3D tungsten photonic crystals with enhanced thermal stability. Chem. Mater. 23, 4783–4788 (2011).

    CAS  Article  Google Scholar 

  14. Rinnerbauer, V. et al. High-temperature stability and selective thermal emission of polycrystalline tantalum photonic crystals. Opt. Express 21, 011482 (2013).

    CAS  Article  Google Scholar 

  15. Lin, S. Y., Moreno, J. & Fleming, J. G. Three-dimensional photonic-crystal emitter for thermal photovoltaic power generation. Appl. Phys. Lett. 83, 380 (2003).

    CAS  Article  Google Scholar 

  16. Chubb, D. L. Fundamentals of Thermophotovoltaic Energy Conversion (Elsevier, 2007).

    Google Scholar 

  17. Lenert, A. et al. A nanophotonic solar thermophotovoltaic device. Nature Nanotech. 9, 126–130 (2014).

    CAS  Article  Google Scholar 

  18. Chan, W. R. et al. Toward high-energy-density, high-efficiency, and moderate-temperature chip-scale thermophotovoltaic. Proc. Natl Acad. Sci. USA 110, 5309–5314 (2013).

    CAS  Article  Google Scholar 

  19. Sharpe, L. T., Stockman, A., Jagla, W. & Jägle, H. A luminous efficiency function, V*(λ), for daylight adaptation. J. Vision 5, 948–968 (2005).

    Article  Google Scholar 

  20. Kostlin, H. & Almer, F. H. R. Incandescent lamp with infrared filter. US patent 4,017,758 (1977).

    Google Scholar 

  21. Goldstein, I. S., Fontana, R. P., Thorington, L. & Howson, R. P. The design, construction and performance of an incandescent light source with a transparent heat mirror. Lighting Res. Technol. 18, 93–97 (1986).

    Article  Google Scholar 

  22. Bergman, R. S. Halogen–IR lamp development: a system approach. J. Illum. Eng. Soc. 20, 10–16 (1991).

    CAS  Article  Google Scholar 

  23. Hecht, E. Optics 4th edn (Addison-Wesley, 2002).

    Google Scholar 

  24. Baumeister, P. Simulation of a rugate filter via a stepped-index dielectric multilayer. Appl. Opt. 25, 2644–2645 (1986).

    CAS  Article  Google Scholar 

  25. Next Generation Luminaires (NGL) Solid-State Lighting Design Competition (2014), sponsored by the US Department of Energy; http://www.ngldc.org

  26. Philips creates the world's most energy-efficient warm white LED lamp Press release (April 2013); http://www.newscenter.philips.com/main/standard/news/press/2013/20130411-philips-creates-the-world-s-most-energy-efficient-warm-white-led-lamp.wpd

  27. Wyszecki, G. & Stiles, W. S. Color Science: Concepts and Methods, Quantitative Data and Formulae 2nd edn (Wiley, 1982).

    Google Scholar 

  28. US Department of Energy, Office of Energy Efficiency and Renewable Energy, CALIPER Snapshot Reports (2014); http://energy.gov/eere/ssl/caliper-snapshot-reports

  29. Lin, S. Y. et al. A three-dimensional photonic crystal operating at infrared wavelengths. Nature 394, 251–253 (1998).

    CAS  Article  Google Scholar 

  30. Fleming, J. G., Lin, S. Y., El-Kady, I., Biswas, R. & Ho, K. M. All-metallic three-dimensional photonic crystals with a large infrared bandgap. Nature 417, 52–55 (2002).

    CAS  Article  Google Scholar 

  31. Touloukian, Y. S. & DeWitt, D. P. Thermophysical Properties of Matter. Thermal Radiative Properties: Metallic Elements and Alloys Vol. 7 (IFI/Plenum, 1970).

    Book  Google Scholar 

  32. Demiryont, H., Sites, J. R. & Geib, K. Effects of oxygen content on the optical properties of tantalum oxide films deposited by ion-beam sputtering. Appl. Opt. 24, 490 (1985).

    CAS  Article  Google Scholar 

  33. Harry, G., Bodiya, T. P. & DeSalvo, R. Optical Coatings and Thermal Noise in Precision Measurement (Cambridge Univ. Press, 2012).

    Google Scholar 

  34. Desai, P. D., Chu, T. K., James, H. M. & Ho, C. Y. Electrical resistivity of selected elements. J. Phys. Chem. Ref. Data 13, 1069–1096 (1984).

    CAS  Article  Google Scholar 

  35. Powell, R. W., Ho, C. Y. & Liley, P. E. Thermal Conductivity of Selected Materials (National Standard Reference Data Series 8, National Bureau of Standards, 1966).

    Book  Google Scholar 

  36. White, G. K. & Collocott, S. J. Heat capacity of reference materials: Cu and W. J. Phys. Chem. Ref. Data 13, 1251–1257 (1984).

    CAS  Article  Google Scholar 

  37. Larouche, S. & Martinu, L. OpenFilters: open-source software for the design, optimization, and synthesis of optical filters. Appl. Opt. 47, C219–C230 (2008).

    Article  Google Scholar 

  38. Tikhonravov, A. V., Trubetskov, M. K. & DeBell, G. W. Application of the needle optimization technique to the design of optical coatings. Appl. Opt. 35, 5493–5508 (1996).

    CAS  Article  Google Scholar 

  39. Johnson, S. G. The NLopt nonlinear-optimization package; http://ab-initio.mit.edu/nlopt

  40. Carniglia, C. K. in Laser-Induced Damage in Optical Materials: 1987 (eds Bennet, H. E. et al.) 272–277 (Special Publication 756, US National Institute of Standards and Technology, 1988).

    Google Scholar 

Download references

Acknowledgements

The authors thank P. Rebusco for critical reading and editing of the manuscript, and J.J. Senkevich, W. Chan, S. Kooi, I. Wang, A. Cukierman, M. Harradon, A. Musabeyoglu, S. Johnson and Y. Xiang Yeng for valuable input. This work was partially supported by the Army Research Office through the ISN (contract no.W911NF-13-D0001). The fabrication part of the effort was supported by S3TEC, an Energy Frontier Research Center funded by the US Department of Energy (DOE), Office of Science, Basic Energy Sciences (BES) (award no. DE-SC0001299/DE-FG02-09ER46577).

Author information

Authors and Affiliations

  1. Research Laboratory of Electronics, Massachusetts Institute of Technology, Cambridge, 02139, Massachusetts, USA

    Ognjen Ilic, John D. Joannopoulos, Ivan Celanovic & Marin Soljačić

  2. School of Electrical and Computer Engineering, Birck Nanotechnology Center, Purdue University, West Lafayette, 47906, Indiana, USA

    Peter Bermel

  3. Department of Mechanical Engineering, Massachusetts Institute of Technology, Cambridge, 02139, Massachusetts, USA

    Gang Chen

Authors
  1. Ognjen Ilic
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Peter Bermel
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Gang Chen
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. John D. Joannopoulos
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. Ivan Celanovic
    View author publications

    You can also search for this author in PubMed Google Scholar

  6. Marin Soljačić
    View author publications

    You can also search for this author in PubMed Google Scholar

Contributions

All authors discussed the results and made critical contributions to the work.

Corresponding author

Correspondence to Ognjen Ilic.

Ethics declarations

Competing interests

The authors declare no competing financial interests.

Supplementary information

Supplementary information

Supplementary information (PDF 966 kb)

Rights and permissions

Reprints and Permissions

About this article

Verify currency and authenticity via CrossMark

Cite this article

Ilic, O., Bermel, P., Chen, G. et al. Tailoring high-temperature radiation and the resurrection of the incandescent source. Nature Nanotech 11, 320–324 (2016). https://doi.org/10.1038/nnano.2015.309

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1038/nnano.2015.309

Further reading

Search

Advanced search

Quick links

Find nanotechnology articles, nanomaterial data and patents all in one place. Visit Nano by Nature Research