Abstract
A 90 degree shoulder is probably the most commonly used margin design for porcelain fused to metal (PFM) restorations. However, this design requires the removal of a significant amount of tooth tissue to provide a predictable restoration. This increases the risk of irreversible damage to the pulp, particularly if little tooth tissue is present, for example on exposed roots. In these situations more conservative designs, such as the 135 degree shoulder or deep chamfer, should be considered. Ideally these designs should be used with an all-metal margin since this is associated with the most predictable marginal seal. Where an all metal margin is aesthetically unacceptable a porcelain butt or subgingival margin can be considered. Newer techniques, such as resin bonded crowns, which minimise tooth destruction and provide acceptable aesthetics may be a viable alternative to traditional PFM restorations. Unfortunately, these newer techniques have not been evaluated long-term
Similar content being viewed by others
Article PDF
Rights and permissions
About this article
Cite this article
Bishop, K., Briggs, P. & Kelleher, M. Margin design for porcelain fused to metal restorations which extend onto the root. Br Dent J 180, 177–184 (1996). https://doi.org/10.1038/sj.bdj.4809011
Published:
Issue Date:
DOI: https://doi.org/10.1038/sj.bdj.4809011
This article is cited by
-
Tooth preparation for full-coverage restorations—a literature review
Clinical Oral Investigations (2015)
-
Relationship Between Periodontics and Restorative Procedures: Surgical Treatment of the Restorative Alveolar Interface (Rai)––Case Series
The Journal of Indian Prosthodontic Society (2013)
-
Crowns and other extra-coronal restorations: Aesthetic control
British Dental Journal (2002)