Capacitive touchscreens are increasingly widespread, featuring in mobile phones and tablets, as well as everyday objects such as cars and home appliances. As a result, the interfaces are uniquely placed to provide a means of communication in the era of the Internet of Everything. Here, we show that commercial touchscreens can be used as reader interfaces for capacitive coupled data transfer. The transfer of data to the touchscreen is achieved using a 12 bit thin-film capacitive radio-frequency identification tag powered by a thin-film battery or a thin-film photovoltaic cell that converts light from the screen. The thin-film integrated circuit has a 0.8 cm2 on-chip monolithic antenna, employs 439 transistors and dissipates only 31 nW of power at a supply voltage of 600 mV. The chip has an asynchronous data rate of up to 36 bps, which is limited by the touchscreen readout electronics.
Subscribe to Journal
Get full journal access for 1 year
only $8.25 per issue
All prices are NET prices.
VAT will be added later in the checkout.
Tax calculation will be finalised during checkout.
Rent or Buy article
Get time limited or full article access on ReadCube.
All prices are NET prices.
The data that support the plots within this paper and other findings of this study are available from the corresponding author upon reasonable request.
Cantatore, E. et al. A 13.56 MHz RFID system based on organic transponders. IEEE J. Solid-State Circ. 42, 84–92 (2007).
Papadopoulos, N. et al. 2-D smart surface object localization by flexible 160-nW monolithic capacitively coupled 12-b identification tags based on metal-oxide TFTs. IEEE Trans. Electron Devices 65, 4861–4867 (2018).
Papadopoulos, N. et al. 1 cm2 sub-1 V capacitive-coupled thin film ID-tag using metal-oxide TFTs on flexible substrate. In 2018 International Flexible Electronics Technology Conference (IFETC) 1–2 (IEEE, 2018); https://doi.org/10.1109/IFETC.2018.8583891
Hung, M.-H. et al. Ultra low voltage 1-V RFID tag implemented in a-IGZO TFT technology on plastic. In IEEE International Conference on RFID 5 (IEEE, 2017).
Myny, K. The development of flexible integrated circuits based on thin-film transistors. Nat. Electron. 1, 30–39 (2018).
Yang, B.-D. A transparent logic circuit for RFID tag in a-IGZO TFT technology. ETRI J. 35, 610–616 (2013).
Myny, K., Tripathi, A. K., van der Steen, J.-L. & Cobb, B. Flexible thin-film NFC tags. IEEE Commun. Mag. 53, 182–189 (2015).
Klauk, H., Zschieschang, U., Pflaum, J. & Halik, M. Ultralow-power organic complementary circuits. Nature 445, 745–748 (2007).
Ke, T.-H. et al. Scaling down of organic complementary logic gates for compact logic on foil. Org. Electron. 15, 1229–1234 (2014).
Myny, K. et al. 15.2 A flexible ISO14443-A compliant 7.5 mW 128 b metal-oxide NFC barcode tag with direct clock division circuit from 13.56 MHz carrier. In 2017 IEEE International Solid-State Circuits Conference (ISSCC) 258–259 (IEEE, 2017); https://doi.org/10.1109/ISSCC.2017.7870359.
Villar, N. et al. Project Zanzibar: a portable and flexible tangible interaction platform. In Proc. 2018 CHI Conference on Human Factors in Computing Systems—CHI ’18 1–13 (ACM Press, 2018).
JOHNSON, E. A. Touch displays: a programmed man-machine interface. Ergonomics 10, 271–277 (1967).
Vu, T. et al. Capacitive touch communication: a technique to input data through devices’ touch screen. IEEE Trans. Mob. Comput. 13, 4–19 (2014).
Coni, P., Perbet, J.-N., Augros, L., Abadie, J. C. & Sontag, Y. 6.1: a new application of a touch screen display for data transfer. SID Symp. Dig. Tech. Pap. 46, 37–40 (2015).
Yu, N.-H. et al. TUIC: enabling tangible interaction on capacitive multi-touch displays. In Proc. 2011 Annual Conference on Human Factors in Computing Systems—CHI ’11 2995 (ACM Press, 2011).
Kubitza, T., Pohl, N., Dingler, T. & Schmidt, A. WebClip: a connector for ubiquitous physical input and output for touch screen devices. In Proc. 2013 ACM International Joint Conference on Pervasive and Ubiquitous Computing—UbiComp ’13 387 (ACM Press, 2013).
Xiao, F., Wang, Z., Ye, N., Wang, R. & Li, X.-Y. One more tag enables fine-grained RFID localization and tracking. IEEE ACM Trans. Netw. 26, 161–174 (2018).
Kronemeijer, A. J. et al. P-127: dual-gate self-aligned IGZO TFTs monolithically integrated with high-temperature bottom moisture barrier for flexible AMOLED. SID Symp. Dig. Tech. Pap. 49, 1577–1580 (2018).
Qiu, W. et al. High efficiency perovskite solar cells using a PCBM/ZnO double electron transport layer and a short air-aging step. Org. Electron. 26, 30–35 (2015).
Qiu, W. et al. An interdiffusion method for highly performing cesium/formamidinium double cation perovskites. Adv. Funct. Mater. 27, 1700920 (2017).
Walker, G. A review of technologies for sensing contact location on the surface of a display: review of touch technologies. J. Soc. Inf. Disp. 20, 413–440 (2012).
Barrett, G. & Omote, R. Projected-Capacitive Touch Technology. Inform. Display 26, 16–21 (2010).
Jang, Y.-S. et al. P-181: a charge-share-based relative read-out circuit for capacitance sensing. SID Symp. Dig. Tech. Pap. 41, 1937–1939 (2010).
Hamaguchi, M., Nagao, A. & Miyamoto, M. 12.3 A 240 Hz-reporting-rate 143×81 mutual-capacitance touch-sensing analog front-end IC with 37 dB SNR for 1 mm-diameter stylus. In 2014 IEEE International Solid-State Circuits Conference Digest of Technical Papers (ISSCC) 214–215 (IEEE, 2014).
Jun, J. et al. In-cell self-capacitive-type mobile touch system and embedded readout circuit in display driver IC. J. Disp. Technol. 12, 1613–1622 (2016).
An, J., Jung, S., Hong, S. & Kwon, O. A highly noise-immune capacitive touch sensing system using an adaptive chopper stabilization method. IEEE Sens. J. 17, 803–811 (2017).
Peumans, P., Yakimov, A. & Forrest, S. R. Small molecular weight organic thin-film photodetectors and solar cells. J. Appl. Phys. 93, 3693–3723 (2003).
Cui, Y. et al. Over 16% efficiency organic photovoltaic cells enabled by a chlorinated acceptor with increased open-circuit voltages. Nat. Commun. 10, 2515 (2019).
Tress, W. et al. Interpretation and evolution of open-circuit voltage, recombination, ideality factor and subgap defect states during reversible light-soaking and irreversible degradation of perovskite solar cells. Energy Environ. Sci. 11, 151–165 (2018).
Huang, T.-C. et al. Pseudo-CMOS: a design style for low-cost and robust flexible electronics. IEEE Trans. Electron Devices 58, 141–150 (2011).
We thank the process engineers of Holst Centre’s GEN1 Pilot Line for fabricating the circuits presented in this paper. This work received funding from the European Research Council (ERC) under the European Union’s Horizon 2020 research and innovation programme under grant agreements 732389 (CAPID project) and 716426 (FLICs project). Part of this work is financed through the Flexlines project within the Interreg V-programme Flanders, The Netherlands, a cross-border cooperation programme with financial support from the European Regional Development Fund, and co-financed by the Province of Noord-Brabant, The Netherlands. W.Q. acknowledges financial support from a postdoctoral researcher grant (12Z4618N) from Research Foundation Flanders (FWO), Belgium.
The authors declare no competing interests.
Publisher’s note Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
About this article
Cite this article
Papadopoulos, N., Qiu, W., Ameys, M. et al. Touchscreen tags based on thin-film electronics for the Internet of Everything. Nat Electron 2, 606–611 (2019). https://doi.org/10.1038/s41928-019-0333-z