Figure 5 | Scientific Reports

Figure 5

From: Electric readout of magnetic stripes in insulators

Figure 5

Writing and reading of magnetic stripes. (a) Procedures for the writing and reading. First, an in-plane magnetic field at an angle α to the y-axis is applied and then it is withdrawn. This procedure writes stripes with the angle α in the YIG. Then, we drop the temperature down to 10 K and measure the resistance of the NbN layer. (b) Results of three runs of writing and reading. α indicates the stripe directions. The error bars represent the standard deviation of measurements. Dotted lines are guides for the eye.

Back to article page