Since the first aeroplane flight more than 100 years ago, aeroplanes have been propelled using moving surfaces such as propellers and turbines. Most have been powered by fossil-fuel combustion. Electroaerodynamics, in which electrical forces accelerate ions in a fluid1,2, has been proposed as an alternative method of propelling aeroplanes—without moving parts, nearly silently and without combustion emissions3,4,5,6. However, no aeroplane with such a solid-state propulsion system has yet flown. Here we demonstrate that a solid-state propulsion system can sustain powered flight, by designing and flying an electroaerodynamically propelled heavier-than-air aeroplane. We flew a fixed-wing aeroplane with a five-metre wingspan ten times and showed that it achieved steady-level flight. All batteries and power systems, including a specifically developed ultralight high-voltage (40-kilovolt) power converter, were carried on-board. We show that conventionally accepted limitations in thrust-to-power ratio and thrust density4,6,7, which were previously thought to make electroaerodynamics unfeasible as a method of aeroplane propulsion, are surmountable. We provide a proof of concept for electroaerodynamic aeroplane propulsion, opening up possibilities for aircraft and aerodynamic devices that are quieter, mechanically simpler and do not emit combustion emissions.
Subscribe to Journal
Get full journal access for 1 year
only $3.90 per issue
All prices are NET prices.
VAT will be added later in the checkout.
Tax calculation will be finalised during checkout.
Rent or Buy article
Get time limited or full article access on ReadCube.
All prices are NET prices.
The data that support the findings of this study are available from the corresponding author upon reasonable request.
Chattock, A. P., Walker, W. E. & Dixon, E. H. IV. On the specific velocities of ions in the discharge from points. Phil. Mag. 1, 79–98 (1901).
Stuetzer, O. M. Ion-drag pumps. J. Appl. Phys. 31, 136–146 (1960).
Christenson, E. A. & Moller, P. S. Ion-neutral propulsion in atmospheric media. AIAA J. 5, 1768–1773 (1967).
Wilson, J., Perkins, H. D. & Thompson, W. K. An Investigation Of Ionic Wind Propulsion. Report No. NASA/TM 2009–215822 (NASA, 2009).
Masuyama, K. & Barrett, S. R. H. On the performance of electrohydrodynamic propulsion. Proc. R. Soc. A 469, 20120623 (2013).
Monrolin, N., Ploouraboué, F. & Praud, O. Electrohydrodynamic thrust for in-atmosphere propulsion. AIAA J. 55, 4296–4305 (2017).
Gilmore, C. K. & Barrett, S. R. H. Electrohydrodynamic thrust density using positive corona-induced ionic winds for in-atmosphere propulsion. Proc. R. Soc. A 471, 20140912 (2015).
Loeb, L. B. Electrical Coronas: Their Basic Physical Mechanisms (Univ. California Press, Berkeley, 1965).
Melcher, J. R. Traveling-wave induced electroconvection. Phys. Fluids 9, 1548 (1966).
Allen, P. H. G. & Karayiannis, T. G. Electrohydrodynamic enhancement of heat transfer and fluid flow. Heat Recovery Syst. 15, 389–423 (1995).
Drew, D. S., Lambert, N. O., Schindler, C. B. & Pister, K. S. J. Toward controlled flight of the ionocraft: a flying microrobot using electrohydrodynamic thrust with onboard sensing and no moving parts. IEEE Robotics Automation Lett. 3, 2807–2813 (2018).
Cumpsty, N. & Heyes, A. Jet Propulsion (Cambridge Univ. Press, Cambridge, 1998).
Leishman, J. G. Principles of Helicopter Aerodynamics (Cambridge Univ. Press, Cambridge, 2000).
Hoburg, W. & Abbeel, P. Geometric programming for aircraft design optimization. AIAA J. 52, 2414–2426 (2014).
Gu, W. J. & Liu, R. A study of volume and weight vs. frequency for high-frequency transformers. In Power Electronics Specialists Conf. 1123–1129 (IEEE, 1993).
He, Y., Woolston, M. R. & Perreault, D. J. Design and implementation of a lightweight high-voltage power converter for electro-aerodynamic propulsion. In IEEE Workshop on Control and Modeling for Power Electronics http://doi.org/10.1109/COMPEL.2017.8013315 (IEEE, 2017).
Hsu, W. C., Chen, J. F., Hsieh, Y. P. & Wu, Y. M. Design and steady-state analysis of parallel resonant DC–DC converter for high-voltage power generator. IEEE Trans. Power Electronics 32, 957–966 (2017).
McFarland, M. W. (ed.) The Papers of Wilbur and Orville Wright (McGraw-Hill, New York, 1953).
The work was also contributed to by many undergraduate students from 2010–2018 as part of MIT’s Undergraduate Research Opportunities Program (UROP), as part of MIT’s Minority Students Research Program (MSRP), or as part of MIT’s summer research exchange program with Imperial College London (IROP). These students include Y. K. Tey, P. Kandangwa, W. B. Rideout, J. Epps, S. O’Neill, M. Adams, J. M. Salinas, N. H. Rodman, I. L. LaJoie, W. A. Rutter, A. J. Sanders, N. J. Martorell, I. Vallina Garcia, J. P. Liguori, K. Dasadhikari, B. J. Scalzo Dees, M. H. Knowles, D. W. Fellows and D. P. Aaradhya. In addition, we thank A. Brown, T. Tao, C. Tan, P. Lozano, J. Peraire and C. Guerra-Garcia for technical discussions and advice, in some cases as part of student thesis committees. K. Masuyama, A. Dexter and J. Payton contributed to the project in its earlier phases. J. Leith and J. L. Freeman contributed to the financial and procurement administration for the project. F. Allroggen contributed to the resource management for the project. We also thank the laboratory staff at MIT AeroAstro for their help with the design, fabrication and flight testing of the EAD aircraft, in particular D. Robertson, T. Billings, A. Zolnik and T. Numan. Finally, we thank the MIT Department of Athletics, Physical Education, and Recreation for access to space for indoor flight testing, in particular S. Lett. This work was funded through MIT Lincoln Laboratory Autonomous Systems Line, the Professor Amar G. Bose Research Grant, and through the Singapore-MIT Alliance for Research and Technology (SMART). The work was also funded through the Charles Stark Draper and Leonardo career development chairs at MIT. This material is based on work supported by the Assistant Secretary of Defense for Research and Engineering under Air Force Contract No. FA8721-05-C-0002 and/or FA8702-15-D-0001. Any opinions, findings, conclusions or recommendations expressed in this material are those of the author(s) and do not necessarily reflect the views of the Assistant Secretary of Defense for Research and Engineering.
Nature thanks D. Drew, K. Pister, F. Plouraboué and H. Smith for their contribution to the peer review of this work.
The authors declare no competing interests.
Publisher’s note: Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Extended data figures and tables
Not to scale. The emitting electrode is a 32 American Wire Gauge (32 AWG; 0.2 mm diameter) stainless steel wire, held at 60 mm spacing from the collecting electrode by 3D-printed spacers. The collecting electrode is a National Advisory Committee for Aeronautics (NACA) 0010 airfoiled foam section covered in a thin layer of aluminium foil. The electrodes are 3 m in span (into the page).
The HVPC is designed to ramp up to the final voltage over 20 s while the aeroplane is on the launcher. The aircraft was in flight for 10–12 s. During flight, the HVPC regulates the output voltage to maintain 40.3 kV.
About this article
Cite this article
Xu, H., He, Y., Strobel, K.L. et al. Flight of an aeroplane with solid-state propulsion. Nature 563, 532–535 (2018). https://doi.org/10.1038/s41586-018-0707-9
- Solid-state Actuators
- Thrust Density
- Steady Level Flight
- High Voltage Power Converter (HVPC)
- Geometric Programming
Empirical relations for discharge current and momentum injection in dielectric barrier discharge plasma actuators
Journal of Physics D: Applied Physics (2021)
Applied Physics Letters (2021)
Journal of Electrostatics (2021)
The electrohydrodynamic force distribution in surface AC dielectric barrier discharge actuators: do streamers dictate the ionic wind profiles?
Journal of Physics D: Applied Physics (2021)
Numerical analysis of electrohydrodynamic flows of a dielectric liquid in a wire–plate configuration with cross Poiseuille flow
Physics of Fluids (2021)