Abstract
The miscibility and crystallization behavior of two binary blends, poly(L-lactide) (PLLA)/poly(ethylene glycol) (PEG) and PLLA/poly(ε-caprolactone) (PCL), with PLLA as the main component (PLLA composition was not lower than 50 wt%) have been investigated by differential scanning calorimetry (DSC) and optical microscopy. PEG and PCL with moderate molecular weight (MW≍10000) were used as the blending components for PLLA. PLLA and PEG were miscible in the melt over the composition range investigated. The variation of the bulk crystallization rate of PLLA with PEG composition displayed a maximum at 10 wt% PEG. On the other hand, a monotonic increase in spherulite growth rate with increasing PEG composition was observed. Since the bulk crystallization rate is determined by both the nucleation density and the growth rate, the depression of nucleation density coupled with the increase of growth rate with increasing PEG composition may give rise to the observed maximum in the composition variation of the bulk crystallization rate. The crystallizability of PLLA and PEG in the blends was also evaluated. The crystallizability of PEG was reduced by blending with PLLA, while that of PLLA was essentially unaffected by blending with PEG. For the PLLA/PCL system, a phase-separated morphology was identified in the melt. However, the crystallization rate of PLLA could be enhanced upon blending with PCL. Since no preferential nucleation at the domain interface was observed, the promotion of PLLA crystallization rate was attributed to its partial miscibility with PCL.
Similar content being viewed by others
Article PDF
References
D. K. Gilding and A. M. Reed, Polymer, 20, 1454 (1979).
T. Hayashi and M. Iwatsuk, Biopolymers, 29, 549 (1990).
N. Kawabata and T. Kurooka, J. Appl. Polym. Sci., 56, 509 (1995).
N. Yoshie, H. Menju, H. Sato, and Y. Inoue, Macromolecules, 28, 6516 (1995).
S. M. Li, I. Rashkov, J. L. Espartero, N. Manolova, and M. Vert, Macromolecules, 29, 57 (1996).
Y. Ikada, K. Jamshida, H. Tsuji, and S.-H. Hyon, Macromolecules, 20, 904 (1987).
H. Younes and D. Cohn, Eur. Polym. J., 24, 765 (1988).
P. Greco and E. Martuscelli, Polymer, 30, 1475 (1989).
H. Tsuji, S.-H. Hyon, and Y. Ikada, Macromolecules, 24, 5651 (1991).
H. Tsuji, S.-H. Hyon, and Y. Ikada, Macromolecules, 24, 5657 (1991).
T. G. Park, S. Cohen, and R. Langer, Macromolecules, 25, 116 (1992).
C. Nakafuku and M. Sakoda, Polym. J., 25, 909 (1993).
S. J. Organ and P. J. Barham, Polymer, 34, 459 (1993).
R. Pearce, G. R. Brown, and R. H. Marchessault, Polymer, 35, 3984 (1994).
R. P. Pearce and R. H. Marchessault, Macromolecules, 27, 3869 (1994).
H. Abe, I. Matsubara, and Y. Doi, Macromolecules, 28, 844 (1995).
M. Scandola, Can. J. Microbiol., 41, 310 (1995).
C. Nakafuku, Polym. J., 28, 568 (1996).
B. Kalb and A. J. Pennings, Polymer, 21, 607 (1980).
H. D. Keith, F. J. Padden, and T. P. Russell, Macromolecules, 22, 666 (1989).
H. Tanaka, T. Hayashi, and T. Nishi, J. Appl. Phys., 59, 3627 (1986).
B. Morra and R. S. Stein, J. Polym. Sci., Polym. Phys. Ed., 20, 2261 (1982).
T. P. Russell and R. S. Stein, J. Polym. Sci., Polym. Phys. Ed., 21, 999 (1983).
B. Wunderlich, “Macromolecular Physics,” Vol. 2, Academic Press, New York, N.Y., 1977.
J. D. Hoffman, G. T. Davis, and J. I. Laurrtzen, Jr., in “Treatise on solid State Chemistry,” N. B. Hanny, Ed., Plenum Press, New York, N.Y., 1976, Chapter 7.
H.-L. Chen, L.-J. Li, W.-C. Ou-Yang, J. C. Hwang, and W. Y. Wong, Macromolecules, accepted.
A. M. Reed and D. K. Guilding, Polymer, 22, 499 (1981).
R. S. Stein, Mater. Res. Soc. Symp. Proc., 321, 531 (1994).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Yang, JM., Chen, HL., You, JW. et al. Miscibility and Crystallization of Poly(L-lactide)/Poly(ethylene glycol) and Poly(L-lactide)/Poly(ε-caprolactone) Blends. Polym J 29, 657–662 (1997). https://doi.org/10.1295/polymj.29.657
Issue Date:
DOI: https://doi.org/10.1295/polymj.29.657
Keywords
This article is cited by
-
Effects of star-shaped PCL having different numbers of arms on the mechanical, morphological, and thermal properties of PLA/PCL blends
Journal of Polymer Research (2021)
-
Properties and phase structure of melt-processed PLA/PMMA blends
Journal of Polymer Research (2018)
-
Significant enhancement of crystallization kinetics of polylactide in its immiscible blends through an interfacial effect from comb-like grafted side chains
Science China Chemistry (2016)
-
Dynamics of partially miscible polylactide-poly(ε-caprolactone) blends in the presence of cold crystallization
Rheologica Acta (2016)
-
Synthesis and properties of Poly(L-lactide)-Poly(ɛ-caprolactone) multiblock copolymers by the self-polycondensation of diblock macromonomers
Polymer Journal (2015)