Skip to main content

Thank you for visiting nature.com. You are using a browser version with limited support for CSS. To obtain the best experience, we recommend you use a more up to date browser (or turn off compatibility mode in Internet Explorer). In the meantime, to ensure continued support, we are displaying the site without styles and JavaScript.

Longitudinal unzipping of carbon nanotubes to form graphene nanoribbons

Abstract

Graphene, or single-layered graphite, with its high crystallinity and interesting semimetal electronic properties, has emerged as an exciting two-dimensional material showing great promise for the fabrication of nanoscale devices1,2,3. Thin, elongated strips of graphene that possess straight edges, termed graphene ribbons, gradually transform from semiconductors to semimetals as their width increases4,5,6,7, and represent a particularly versatile variety of graphene. Several lithographic7,8, chemical9,10,11 and synthetic12 procedures are known to produce microscopic samples of graphene nanoribbons, and one chemical vapour deposition process13 has successfully produced macroscopic quantities of nanoribbons at 950 °C. Here we describe a simple solution-based oxidative process for producing a nearly 100% yield of nanoribbon structures by lengthwise cutting and unravelling of multiwalled carbon nanotube (MWCNT) side walls. Although oxidative shortening of MWCNTs has previously been achieved14, lengthwise cutting is hitherto unreported. Ribbon structures with high water solubility are obtained. Subsequent chemical reduction of the nanoribbons from MWCNTs results in restoration of electrical conductivity. These early results affording nanoribbons could eventually lead to applications in fields of electronics and composite materials where bulk quantities of nanoribbons are required15,16,17.

Your institute does not have access to this article

Relevant articles

Open Access articles citing this article.

Access options

Buy article

Get time limited or full article access on ReadCube.

$32.00

All prices are NET prices.

Figure 1: Nanoribbon formation and imaging.
Figure 2: Stepwise opening of MWCNTs to form nanoribbons.
Figure 3: Characterization of the oxidized and reduced nanoribbons derived from MWCNTs.
Figure 4: Device fabrication and electrical properties of graphene nanoribbons on SiO 2 –Si.

References

  1. Geim, A. K. & Novoselov, K. S. The rise of graphene. Nature Mater. 6, 183–191 (2007)

    ADS  CAS  Article  Google Scholar 

  2. Novoselov, K. S. et al. Two-dimensional gas of massless Dirac fermions in graphene. Nature 438, 197–200 (2005)

    ADS  CAS  Article  Google Scholar 

  3. Zhang, Y., Tan, Y.-W., Stormer, H. L. & Kim, P. Experimental observation of the quantum Hall effect and Berry’s phase in graphene. Nature 438, 201–204 (2005)

    ADS  CAS  Article  Google Scholar 

  4. Areshkin, D. A., Gunlycke, D. & White, C. T. Ballistic transport in graphene nanostrips in the presence of disorder: importance of edge effects. Nano Lett. 7, 204–210 (2007)

    ADS  CAS  Article  Google Scholar 

  5. Nakada, K., Fujita, M., Dresselhaus, G. & Dresselhaus, M. S. Edge state in graphene ribbons: nanometer size effect and edge shape dependence. Phys. Rev. B 54, 17954–17961 (1996)

    ADS  CAS  Article  Google Scholar 

  6. Son, Y.-W., Cohen, M. L. & Louie, S. G. Energy gaps in graphene nanoribbons. Phys. Rev. Lett. 97, 216803 (2006)

    ADS  Article  Google Scholar 

  7. Han, M. Y., Oezyilmaz, B., Zhang, Y. & Kim, P. Energy band-gap engineering of graphene nanoribbons. Phys. Rev. Lett. 98, 206805 (2007)

    ADS  Article  Google Scholar 

  8. Chen, Z., Lin, Y.-M., Rooks, M. J. & Avouris, P. Graphene nano-ribbon electronics. Physica E 40, 228–232 (2007)

    ADS  CAS  Article  Google Scholar 

  9. Schniepp, H. C. et al. functionalized single graphene sheets derived from splitting graphite oxide. J. Phys. Chem. B 110, 8535–8539 (2006)

    CAS  Article  Google Scholar 

  10. Rollings, E. et al. Synthesis and characterization of atomically thin graphite films on a silicon carbide substrate. J. Phys. Chem. Solids 67, 2172–2177 (2006)

    ADS  CAS  Article  Google Scholar 

  11. Li, X., Wang, X., Zhang, L., Lee, S. & Dai, H. Chemically derived, ultrasmooth graphene nanoribbon semiconductors. Science 319, 1229–1232 (2008)

    ADS  CAS  Article  Google Scholar 

  12. Yang, X. et al. Two-dimensional graphene nanoribbons. J. Am. Chem. Soc. 130, 4216–4217 (2008)

    CAS  Article  Google Scholar 

  13. Campos-Delgado, J. et al. Bulk production of a new form of sp2 carbon: crystalline graphene nanoribbons. Nano Lett. 8, 2773–2778 (2008)

    ADS  CAS  Article  Google Scholar 

  14. Saito, T., Matsushige, K. & Tanaka, K. Chemical treatment and modification of multi-walled carbon nanotubes. Physica B 323, 280–283 (2002)

    ADS  CAS  Article  Google Scholar 

  15. Son, Y.-W., Cohen, M. L. & Louie, S. G. Half-metallic graphene nanoribbons. Nature 444, 347–349 (2006)

    ADS  CAS  Article  Google Scholar 

  16. Liang, G., Neophytou, N., Nikonov, D. E. & Lundstrom, M. S. Performance projections for ballistic graphene nanoribbon field-effect transistors. IEEE Trans. Electron. Dev. 54, 677–682 (2007)

    ADS  CAS  Article  Google Scholar 

  17. Wang, X. et al. Room-temperature all-semiconducting sub-10-nm graphene nanoribbon field-effect transistors. Phys. Rev. Lett. 100, 206803 (2008)

    ADS  Article  Google Scholar 

  18. Li, J.-L. et al. Oxygen-driven unzipping of graphitic materials. Phys. Rev. Lett. 96, 176101 (2006)

    ADS  Article  Google Scholar 

  19. Ajayan, P. M. & Yakobson, B. I. Oxygen breaks into carbon world. Nature 441, 818–819 (2006)

    ADS  CAS  Article  Google Scholar 

  20. Wolfe, S., Ingold, C. F. & Lemieux, R. U. Oxidation of olefins by potassium permanganate: mechanism of α-ketol formation. J. Am. Chem. Soc. 103, 938–939 (1981)

    CAS  Article  Google Scholar 

  21. Banoo, F. & Stewart, R. Mechanisms of permanganate oxidation. IX. Permanganate oxidation of aromatic alcohols in acid solution. Can. J. Chem. 47, 3199–3205 (1969)

    CAS  Article  Google Scholar 

  22. Endo, M. Grow carbon fibers in the vapor phase. Chemtech 18, 568–576 (1988)

    CAS  Google Scholar 

  23. Hummers, W. S. & Offeman, R. E. Preparation of graphitic oxide. J. Am. Chem. Soc. 80, 1339 (1958)

    CAS  Article  Google Scholar 

  24. Lerf, A., He, H., Forster, M. & Klinowski, J. Structure of graphite oxide revisited. J. Phys. Chem. B 102, 4477–4482 (1998)

    CAS  Article  Google Scholar 

  25. Li, D., Mueller, M. B., Gilje, S., Kaner, R. B. & Wallace, G. G. Processable aqueous dispersions of graphene nanosheets. Nature Nanotechnol. 3, 101–105 (2008)

    ADS  CAS  Article  Google Scholar 

  26. Stankovich, S. et al. Synthesis of graphene-based nanosheets via chemical reduction of exfoliated graphite oxide. Carbon 45, 1558–1565 (2007)

    CAS  Article  Google Scholar 

  27. Bourlinos, A. B. et al. Graphite oxide: chemical reduction to graphite and surface modification with primary aliphatic amines and amino acids. Langmuir 19, 6050–6055 (2003)

    CAS  Article  Google Scholar 

  28. Eda, G., Fanchini, G. & Chhowalla, M. Large-area ultrathin films of reduced graphene oxide as a transparent and flexible electronic material. Nature Nanotechnol. 3, 270–274 (2008)

    CAS  Article  Google Scholar 

  29. Stankovich, S. et al. Stable aqueous dispersions of graphitic nanoplatelets via the reduction of exfoliated graphite oxide in the presence of poly(sodium 4-styrenesulfonate). J. Mater. Chem. 16, 155–158 (2006)

    CAS  Article  Google Scholar 

  30. Novoselov, K. S. et al. Electric field effect in atomically thin carbon films. Science 306, 666–669 (2004)

    ADS  CAS  Article  Google Scholar 

Download references

Acknowledgements

The authors thank P. M. Ajayan, W. Guo, J. Duque, Z. Sun, and Z. Jin for technical assistance and discussions. Mitsui & Co. generously donated the MWCNTs. The work was funded by the US Defense Advanced Research Projects Agency, the US Federal Aviation Administration, Department of Energy (DE-FC-36-05GO15073) and Wright Patterson Air Force Laboratory through the US Air Force Office of Scientific Research.

Author Contributions D.V.K. discovered the unzipping reaction and made most of the analysed ribbons. A.L.H. obtained and analysed most of the analysis data including the TEM, AFM, ultraviolet, XPS, TGA, Raman and infrared data; she also made some of the ribbons and wrote the majority of the manuscript. A.S. fabricated and tested the electronic devices. J.R.L performed some of the spectral analysis including the X-ray diffraction. A.D. prepared and studied the nanoribbons on silicon surfaces for electrical analysis. B.K.P. performed some of the AFM analyses. J.M.T. oversaw and directed all aspects of the syntheses, data analysis and manuscript correction and finalization.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to James M. Tour.

Supplementary information

Supplementary information

This file contains Supplementary Figures S1-S6, Supplementary Data and Supplementary References. (PDF 540 kb)

PowerPoint slides

Rights and permissions

Reprints and Permissions

About this article

Cite this article

Kosynkin, D., Higginbotham, A., Sinitskii, A. et al. Longitudinal unzipping of carbon nanotubes to form graphene nanoribbons. Nature 458, 872–876 (2009). https://doi.org/10.1038/nature07872

Download citation

  • Received:

  • Accepted:

  • Issue Date:

  • DOI: https://doi.org/10.1038/nature07872

Further reading

Comments

By submitting a comment you agree to abide by our Terms and Community Guidelines. If you find something abusive or that does not comply with our terms or guidelines please flag it as inappropriate.

Search

Quick links

Nature Briefing

Sign up for the Nature Briefing newsletter — what matters in science, free to your inbox daily.

Get the most important science stories of the day, free in your inbox. Sign up for Nature Briefing