Skip to main content

Thank you for visiting You are using a browser version with limited support for CSS. To obtain the best experience, we recommend you use a more up to date browser (or turn off compatibility mode in Internet Explorer). In the meantime, to ensure continued support, we are displaying the site without styles and JavaScript.

A field comparison of two methods for sampling lead in household dust


Comparability of dust lead measurements has been a difficult problem due to different sampling and analysis techniques. This paper compares two dust sampling techniques, the U.S. Department of Housing and Urban Development (HUD) dust wipe method and the Lioy, Wainman, Weisel (LWW) sampler. The HUD method specifies using a moist towelette to pick up as much dust as possible in a specified area and estimates total lead loading. The LWW sampler collects the dust on preweighed wetted filter media, and provides greater standardization of the sampling path and pressure applied. LWW samples were analyzed using inductively coupled plasma mass spectronomy (no samples below minimum detection limit), while HUD samples were analyzed using flame atomic absorption (32% of samples below minimum detection limit). A bootstrapping technique was used in the analysis to contend with those HUD samples below the minimum detection limit. Mixed model equations were generated to predict HUD values from LWW results, and to examine the effects of sampling location, time, and method. The results indicate that the two samplers performed similarly under field conditions, although the LWW sampler produced consistently lower lead loading estimates. LWW values that predicted HUD lead clearance values of 100 μg/ft2 for floors and 500 μg/ft2 for window sills were 72 μg/ft2 and 275 μg/ft2, respectively. To examine internal reproducibility, duplicate samples were taken using both the HUD and LWW methods. Correlation results within paired samples indicated a statistically significantly higher (p<0.001) internal reproducibility for lead loading, for the LWW sampler (r=0.87), than for the HUD method (r=0.71). Some of the differences appeared to be related to the analytical methods.

This is a preview of subscription content, access via your institution

Access options

Rent or buy this article

Prices vary by article type



Prices may be subject to local taxes which are calculated during checkout

Author information

Authors and Affiliations


Corresponding author

Correspondence to GEORGE G RHOADS.

Rights and permissions

Reprints and Permissions

About this article

Cite this article

RICH, D., YIIN, LM., RHOADS, G. et al. A field comparison of two methods for sampling lead in household dust. J Expo Sci Environ Epidemiol 9, 106–112 (1999).

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI:


  • clearance values
  • dust
  • HUD dust wipe
  • lead
  • LWW sampler
  • sampling


Quick links