Abstract
THE following method of developing a latent Lichtenberg figure on the surface of certain types of solid dielectrics is very successful. So far, only a 'silicon' type of synthetic resin, 'Novalak' (fusible phenol formaldehyde polymer), ester gum and cumar resin have been used; but it appears necessary merely that the dielectric should be hard and brittle at ordinary temperatures and should soften quickly at some higher temperature. For example, in one experiment a piece of the resin was fused and poured on a clean glass plate to form, when cool, a hard smooth and uniform coating. This was placed between a needle point and an earthed metal plate. A single positive (or negative) voltage surge of magnitude 10 kV. was applied. No change of the surface was visible. On gently heating the resin coating, however, until the softening temperature was just reached, thread-like grooves appeared which, in a few moments, assumed the characteristic form of a Lichtenberg figure. At this instant the heating was stopped, otherwise the figure disappeared rapidly as the resin liquefied.
Similar content being viewed by others
Article PDF
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
THOMAS, A. Electric Discharge on a Dielectric Surface (Lichtenberg Figures). Nature 156, 451 (1945). https://doi.org/10.1038/156451a0
Issue Date:
DOI: https://doi.org/10.1038/156451a0
Comments
By submitting a comment you agree to abide by our Terms and Community Guidelines. If you find something abusive or that does not comply with our terms or guidelines please flag it as inappropriate.