Letter | Published:

User-interactive electronic skin for instantaneous pressure visualization

Nature Materials volume 12, pages 899904 (2013) | Download Citation

Abstract

Electronic skin (e-skin) presents a network of mechanically flexible sensors that can conformally wrap irregular surfaces and spatially map and quantify various stimuli1,2,3,4,5,6,7,8,9,10,11,12. Previous works on e-skin have focused on the optimization of pressure sensors interfaced with an electronic readout, whereas user interfaces based on a human-readable output were not explored. Here, we report the first user-interactive e-skin that not only spatially maps the applied pressure but also provides an instantaneous visual response through a built-in active-matrix organic light-emitting diode display with red, green and blue pixels. In this system, organic light-emitting diodes (OLEDs) are turned on locally where the surface is touched, and the intensity of the emitted light quantifies the magnitude of the applied pressure. This work represents a system-on-plastic4,13,14,15,16,17 demonstration where three distinct electronic components—thin-film transistor, pressure sensor and OLED arrays—are monolithically integrated over large areas on a single plastic substrate. The reported e-skin may find a wide range of applications in interactive input/control devices, smart wallpapers, robotics and medical/health monitoring devices.

Access optionsAccess options

Rent or Buy article

Get time limited or full article access on ReadCube.

from$8.99

All prices are NET prices.

References

  1. 1.

    et al. A large-area, flexible pressure sensor matrix with organic field-effect transistors for artificial skin applications. Proc. Natl Acad. Sci. USA 101, 9966–9970 (2004).

  2. 2.

    et al. Conformable, flexible, large-area networks of pressure and thermal sensors with organic transistor active matrixes. Proc. Natl Acad. Sci. USA 102, 12321–12325 (2005).

  3. 3.

    et al. Electronic skin: Architecture and components. Physica E 25, 326–334 (2004).

  4. 4.

    & Stretchable, large-area organic electronics. Adv. Mater. 22, 2228–2246 (2010).

  5. 5.

    et al. Nanowire active-matrix circuitry for low-voltage macroscale artificial skin. Nature Mater. 9, 821–826 (2010).

  6. 6.

    et al. Highly sensitive flexible pressure sensors with microstructured rubber dielectric layers. Nature Mater. 9, 859–864 (2010).

  7. 7.

    et al. Epidermal electronics. Science 333, 838–843 (2011).

  8. 8.

    et al. Skin-like pressure and strain sensors based on transparent elastic films of carbon nanotubes. Nature Nanotech. 6, 788–792 (2011).

  9. 9.

    , , , & Carbon nanotube active-matrix backplanes for conformal electronics and sensors. Nano Lett. 11, 5408–5413 (2011).

  10. 10.

    , , & An electrically and mechanically self-healing composite with pressure- and flexion-sensitive properties for electronic skin applications. Nature Nanotech. 7, 825–831 (2012).

  11. 11.

    , , & Highly sensitive skin-mountable strain gauges based entirely on elastomers. Adv. Funct. Mater. 22, 4044–4050 (2012).

  12. 12.

    et al. A flexible and highly sensitive strain-gauge sensor using reversible interlocking of nanofibres. Nature Mater. 11, 795–801 (2012).

  13. 13.

    , & Materials and mechanics for stretchable electronics. Science 327, 1603–1607 (2010).

  14. 14.

    , , , & Stretchable, curvilinear electronics based on inorganic materials. Adv. Mater. 22, 2108–2124 (2010).

  15. 15.

    et al. Organic nonvolatile memory transistors for flexible sensor arrays. Science 326, 1516–1519 (2009).

  16. 16.

    et al. Printed assemblies of inorganic light-emitting diodes for deformable and semitransparent displays. Science 325, 977–981 (2009).

  17. 17.

    , , & Carbon nanotube electronics—moving forward. Chem. Soc. Rev. 42, 2592–2609 (2013).

  18. 18.

    , , , & Sorting carbon nanotubes by electronic structure using density differentiation. Nature Nanotech. 1, 60–65 (2006).

  19. 19.

    et al. Medium-scale carbon nanotube thin-film integrated circuits on flexible plastic substrates. Nature 454, 495–500 (2008).

  20. 20.

    et al. Flexible high-performance carbon nanotube integrated circuits. Nature Nanotech. 6, 156–161 (2011).

  21. 21.

    & Ultrathin films of single-walled carbon nanotubes for electronics and sensors: A review of fundamental and applied aspects. Adv. Mater. 21, 29–53 (2009).

  22. 22.

    et al. Separated carbon nanotube macroelectronics for active matrix organic light-emitting diode displays. Nano Lett. 11, 4852–4858 (2011).

  23. 23.

    & Organic electroluminescent diodes. Appl. Phys. Lett. 51, 913–915 (1987).

  24. 24.

    , & Conductive rubber materials for pressure sensors. J. Mater. Sci. Lett. 20, 525–527 (2001).

  25. 25.

    , , , & A tactile sensor sheet using pressure conductive rubber with electrical-wires stitched method. IEEE Sensors J. 4, 589–596 (2004).

  26. 26.

    , , & Highly ordered nanowire arrays on plastic substrates for ultrasensitive flexible chemical sensors. Nature Mater. 6, 379–384 (2007).

  27. 27.

    Three-dimensional, flexible nanoscale field-effect transistors as localized bioprobes. Science 329, 830–834 (2010).

  28. 28.

    et al. A hemispherical electronic eye camera based on compressible silicon optoelectronics. Nature 454, 748–753 (2008).

  29. 29.

    , , & Transparent, optical, pressure sensitive artificial skin for large-area stretchable electronics. Adv. Mater. 24, 3223–3227 (2012).

  30. 30.

    et al. A stretchable carbon nanotube strain sensor for human-motion detection. Nature Nanotech. 6, 296–301 (2011).

Download references

Acknowledgements

This work was funded by DARPA/DSO Maximum Mobility and Manipulation. OLED processing was performed as a user project in the Molecular Foundry, supported by the Office of Science, Office of Basic Energy Sciences, of the US Department of Energy under Contract No. DE-AC02-05CH11231. Some of the materials and optical characterization was performed in the Electronic Materials Laboratory at LBNL, which is supported by the Director, Office of Science, Office of Basic Energy Sciences, Materials Sciences and Engineering Division, of the US Department of Energy under Contract No. DE-AC02-05CH11231. A.J. acknowledges support from the World Class University programme at Sunchon National University.

Author information

Author notes

    • Chuan Wang

    Present address: Department of Electrical and Computer Engineering, Michigan State University, East Lansing, Michigan 48824, USA

Affiliations

  1. Department of Electrical Engineering and Computer Sciences, University of California, Berkeley, California 94720, USA

    • Chuan Wang
    • , David Hwang
    • , Zhibin Yu
    • , Kuniharu Takei
    •  & Ali Javey
  2. Berkeley Sensor and Actuator Center, University of California, Berkeley, California 94720, USA

    • Chuan Wang
    • , David Hwang
    • , Zhibin Yu
    • , Kuniharu Takei
    •  & Ali Javey
  3. Materials Sciences Division, Lawrence Berkeley National Laboratory, Berkeley, California 94720, USA

    • Chuan Wang
    • , David Hwang
    • , Zhibin Yu
    • , Kuniharu Takei
    • , Biwu Ma
    •  & Ali Javey
  4. The Molecular Foundry, Lawrence Berkeley National Laboratory, Berkeley, California 94720, USA

    • Junwoo Park
    • , Teresa Chen
    •  & Biwu Ma

Authors

  1. Search for Chuan Wang in:

  2. Search for David Hwang in:

  3. Search for Zhibin Yu in:

  4. Search for Kuniharu Takei in:

  5. Search for Junwoo Park in:

  6. Search for Teresa Chen in:

  7. Search for Biwu Ma in:

  8. Search for Ali Javey in:

Contributions

C.W. and A.J. conceived the idea and designed the experiments. C.W. carried out the device fabrication and electrical characterization. C.W., D.H., Z.Y., J.P., T.C. and B.M. contributed to the OLED fabrication and characterization. K.T. helped with the shadow mask fabrication. C.W., Z.Y. and A.J. contributed to analysing the data. C.W. and A.J. wrote the paper and all authors provided feedback.

Competing interests

The authors declare no competing financial interests.

Corresponding author

Correspondence to Ali Javey.

Supplementary information

PDF files

  1. 1.

    Supplementary Information

    Supplementary Information

Videos

  1. 1.

    Supplementary Information

    Supplementary Movie S1

About this article

Publication history

Received

Accepted

Published

DOI

https://doi.org/10.1038/nmat3711

Further reading